Official Site - HY-SAVE® Refrigeration Energy Saving LPA® Products

Welcome

Welcome to our products guide. Our aim is to provide you with the latest most updated product information and specifications. Our latest products will be featured in these sliding banners while existing products will be available under the various categories below.
Our products section is currently open for comments as your feedback is very important for us.

As we are currently in process of adding products to this section, not all the products you may be looking could be available. Please contact us for any specifics.

Facts about the LPA Pump

The LPA® pump is a semi-hermetically sealed unit with important design features: The impeller floats in a revolving magnetic field and is the only moving part. The magnetic flux is supplied by an external motor with a magnetic coupling device. Because the motor is external to the system, a burnout cannot contaminate the system. The [...]

A Cool Solution for Humidity Problems – HY-DRY

HY-DRY™ patented technology provides an affordable moisture removal increase by as much as 70% relative to existing systems without HY-DRY™. This lower humidity allows your building to change from “cold and clammy” to cool and dry fresh air. Everyone in the building will enjoy the ultimate comfort.

PumpPro III Version 2 1.07 January 2010

To control HY-SAVE® LPA® pumps during operation and to protect from loss of refrigerants or unstable system performance.

HY-SAVE Model LDS-860-2-340

Nominal Flow at 50hz 135 litres/min
Nominal Head at nominal flow 9 metres

DX Free Cooling

Model DX-860-2-200
DX Free Cooling is achieved when ambient temperatures are 5′C to 8′C (10F to 16F) below the air off or water leaving temperature set points. As the ambient temperature falls below a predetermined set point, the LPA® pumps and condenser fans continue to run while the vapour returning from the evaporators or heat exchanges by-passes the compressors allowing the compressors to cycle off during the Free Cooling cycle.

Model LDS-875-1-200

Capacity Overview

Nominal Flow 100 litres/min (26 GPM)
Nominal Head 10 Metres (30 feet)

Welcome to our products page.

Our aim is to provide you with our latest information and the products we are offering to improve your system performance and make refrigeration plant substantially more efficient. The products we highlight in these categories are our standard products and suitable for most refrigerant plant. Our full range of LPA® and LDS™ start from 25 to 1,500 kW of cooling capacity (7 to 426 tons). For other sizes or capacity requirements, please contact us.

As our site is being continually updated to provide you with our latest product information, not all the products you may be looking for may be listed at this moment in time. Please check back with us every so often or contact us for any specific information today.